Here you can download free xm360.2.0d shared files found in our database: XM360 v2.0d.zip from 4shared.com host Nandpro 2 0d rar mediafire.com (2 MB) Royalhack 2 0d. UPDATED NAND/JTAG SOFTWARE TUTORIAL ( JULY 9th 2010). Nandpro 20d drivers.rar Then use video tutorial for Flashing Xell / Xbreboot (Jtag Tool Tutorial) First of all IS YOUR XBOX EXPLOITABLE? - JTAG-Compatible-Dash.pdf The NAND-X is very easy to install. Tutorial, compatible, install, exploitable, flashing.

Code: =============================================================================== SUPPORTED DEVICE INTERFACES =============================================================================== USB: LPC2148 Olimex USB header board. High performance 16MB/2Mins. LibUsb driver. LPT: Parallel Printer Port, SPP mode. Low performance, 16MB/35mins (cpu dependant).

Dlportio printer port driver. XSVF: Subset device of USB.

LPC2148 Olimex USB header board required. NOT for nand programming. This command line device type is for flashing.xsvf files to a Xilinx cpld. POST: Subset device of USB. LPC2148 Olimex USB header board required.

NOT for nand programming. This command line device type is for monitoring Post codes only. The included.hex file supports both Nand SPI flash, Xilinx Programming, and Post Monitor all at the same time. The mode selected ie: Nand Flash/Xsvf/PostMon is determined by the command line. Previous.hex files as well as the 'pic' version of hardware will not work. The Maximus 'NANDFlasher' has an array of plated through holes to break out all the extra LPC2148 gpio. This product can be flashed with the new ArmV3.hex file for full comatibility with Nandpro.

The wiring coordinates are included here for those who have this device. The included.jpg file shows the connections to flash this device with the Philips utility. An RS232 level shifter is also required for this purpose.

The Team Executor 'NAND-X' can also be flashed with the ArmV3.hex, however the wiring connections may be difficult, and are not listed in this document. =============================================================================== DRIVER AND HARDWARE INSTALLATION =============================================================================== USB Install: Flash the. Equation Plus Acm 2600 Manual here. hex file to the LPC2148 using the 'Philips LPC2000 FlashUtility' or equivalent. Connect LPC2148 to computer USB. Point 'found new hardware' to the 'custom.inf' Windows reports: 'Your new hardware is ready to use' USB Hardware: Connect only wires from EXT connectors to MAINBRD where indicated.

Connect only wires from EXT connectors to Xilinx jtag connector where indicated. No resistors or diodes at all. Do not add them!

=============================================================================== LPT Install: Run the port95nt.exe application to install the DlPortio driver LPT Hardware: Some parallel ports run at 3.3v others at 5v. The MAINBRD is 3.3 volts. It is recommend to use 100 ohm series saftey resistors (R) for all lpt connections except for DB25.11 and DB25.18 (GND), as shown above. Testing with 5 volt lpt and NO resistors didn't burn anything up though. YMMV Tongue For DB25.11 connect diode exactly as shown. It is highly recommended to connect the diode to the MAINBRD end rather than the PC end of the wire.