• DiamonD Tech innovations For creativity DL 5000 DiamonD Laser BanD saw OperatiOns manual. • • Donotoperatewhileundertheinfluenceofmedicationoralcohol. • Toensuretopperformancekeepbandsawproperlymaintained. Contents Your Diamond Laser 5000 has been shipped partially ™ assembled. Carefully remove saw and parts from the packaging. 1-Band saw Body 2-cutting Table 3-recirculating water pump and valve 4-Detachable water reservoir 5-straight edge/angle cutting Guide.

• 5) Fill the reservoir with 2” of water before use (approximately 3 quarts). 6) To test pump, the saw must be turned on. Be sure the blade has been properly installed and there are no obstructions to interfere with its operation and blade movement.

Products 1 - 12 of 281 - Diamond E-1000-E-1000i DS 1016revE 2.pdf. Liquid-Cooled, RF-Excited OEM Industrial CO2 Laser Diamond E-1000/E-1000i preliminary System Specifications1 Diamond E-1000 Diamond E-1000i Wavelength (µm) 10.2 to 10.8 9.1 to 9.5 Output Power2 (W) >_1000 Power Range3 (W) 100 to 1000. You are bidding on a DIAMOND LASER 1000, TWO WHEEL DRIVE WET BAND SAW. This band saw will allow you to cut those IMPOSSIBLE CUTS that you can't do by hand,instructions are included. Band saw is u.from eBay.

Do noT attempt to touch the blade or blade wheels while the machine is turned on. • 1) To tighten the drive belt, turn saw oFF and unplug the saw from the electrical outlet. 2) remove all screws securing rear panel encasing the motor (Fig.10). • To adjust height of blade guide, loosen guide bar locking knob on back of saw and raise or lower the guide assembly (Fig. Straight edge / Angle guide The band saw is designed for intricate radius cuts, however the straightedgeguidewillpermitmoderatestraightedgeorfixedangle cutting when needed. • 3) To back out of a cut, turn the saw off and ease the material away from the blade. 4) clean band saw after each use with water.

Run clean water through pump until it runs clear and the water tube appears clean. • Diamond Tech offers a blade repair service should a blade break with ample diamond remaining. Return blade, indicating saw model and payment to Diamond tech, Blade repair service, 5600 airport Blvd., suite C,tampa, Fl 33634. For international and special handling, please include extra postage and shipping instructions Blade Repair Fees (U.S. • 800-937-9593 or email info@dticrafts.com for a return authorization number.

Equipment will not be accepted at Diamond Tech without a return authorization number. If returning the Band saw for evaluation or repair, be sure to include your name, address, Daytime phoneNumberwithAreaCodeandaletterexplainingthespecificproblemyouareencountering.

Klingon Academy 1.02 Patch Download. Please Read Before Continuing Risk factors: Except for the historical information contained here, many of the matters discussed in this Web site are forward-looking statements, based on expectations at the time they were made, that involve risks and uncertainties that could cause our results to differ materially from those expressed or implied by such statements. These risks are detailed in the “Factors That May Affect Future Results” section of our latest 10-K or 10-Q filing. Coherent assumes no obligation to update these forward-looking statements.